Sony KP-61XBR300 - Manual (Page 6)

Using this Manual
W'c avomiuciKl lluil sou carofulls res less liu-
coiilcms of ills' follow ing four ss-s'tions in Ills' Ol sis'l
pros isis'si
10 s'lisurs' Ilinl ysHi fully unsls'rsUlllsl ills'
operation of s'our noss' projes'tion TV.
1 Installing and Connecting the Projection TV
This section guides you through your initial set
up. It shoss's you hosv to install your projection
TV, to connect your nesv components and to
connect to the antenna and cable.
2 Basic Setup
This section teaches you the basic skills needed
to operate your new projection TV, including
Easy Set Up. It shows you how to operate the
remote control's special functions.
3 Using Your New Projection TV
This section shows you how to begin using
your new projection TV. It shows you how’ to
use your remote control’s features.
4 Adjusting Your Set Up (menus)
This section teaches you how to access on­
screen menus and adjust your projection TV’s
settings.
Instructions in this manual are written for the remote
control. Similar controls may be found on the
projection TV console.
Precautions
Safety
• Operate the projeetion TV onh on 110 V AC.
• The plug is designed. Гог sat'ety punx'ses. to tit into
the wall outlet only one way. It you are unable to
insert the plug fully into the outlet, eoniaei your
dealer.
• If any liquid or solid object should fall inside the
cabinet, unplug the projection TV immediately and
have it checked by qualified service personnel
before operating it further.
• If you will not be using the projection TV for
several days, disconnect the power by pulling the
plug itself. Never pull on the cord.
For details concerning safety precautions, see the
supplied leaflet "¡MPORTANT SAFEGUARDS."
Note on cleaning
Clean the cabinet of the projection TV with a dry
soft cloth. To remove dust from the screen, wipe it
gently with a soft cloth. Stubborn stains may be
removed with a cloth slightly dampened with
solution of mild soap and warm water. Never use
strong solvents such as thinner or benzine for
cleaning.
If the picture becomes dark after using the
projection TV for a long period of time, it may be
necessary to clean the inside of the projection TV.
Consult qualified service personnel.
Installing
• To picNOiii iniom.il boat buildup, do nol bUvk the
vontilation openings.
• Do nol install the projection TV in a hot or humid
place, or in a place subject to excessive dust or
mechanical vibration.
• Avoid operating the projection TV at temperature
below .S"C (4I "F).
• If the projection TV is transported directly from a
cold to a warm location, or if the room temperature
changes suddenly, the picture may be blurred or
show poor color. In this ca.se. plea.se wail a few
hours to let the moisture evaporate before turning
on the projection TV.
• To obtain the best picture, do not expose the screen
to direct illumination or direct sunlight. It is
recommended to use spot lighting directed down
from the ceiling or to cover the windows that face
the screen with opaque drapery. It is desirable to
install the projection TV in a room where the floor
and walls are not of a reflective material.