Warning, Information, Caution – Sony STR-DA80ES User Manual
Page 2: Note to catv system installer, Owner's record, For the customers in canada caution, Precautions, On safety, On power sources, On placement
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
 
WARNING
To prevent fire or shock
hazard, do not expose
the unit to rain or
moisture.
A
This symbol is intended to alert the user 
to the presence of uninsulated 
"dangerous voltage" within the 
product's enclosure that may be of 
sufficient magnitude to constitute a risk 
of electric shock to persons.
A
This symbol is intended to alert the user 
to the presence of important operating 
and maintenance (servicing) 
instructions in the literature 
accompanying die appliance.
INFORMATION
This equipment has been tested and
found to comply widi die limits for a 
Oass B digital device, pursuant to Part 
15 of the FCC Rules.
These limits are designed to provide 
reasonable protection against harmful 
interference in a residential installation. 
This equipment generates, uses, and can 
radiate radio ^equency energy and, if 
not installed and used in accordance 
with the instructions, may cause 
harmful interference to radio 
communications. However, there is no 
guarantee that interference will not 
occur in a particular installation. If this 
equipment dd№ cause harmful 
interference to radio or television 
reception, which can be determined by 
turning the equipment off and on, the 
user is encouraged to try to correct the 
interference by one or more of the 
following measures:
- Reorient or relocate the receiving
antenna.
- Increase the separation between the
equipment and receiver.
- Connect the equipment into an outlet
on a circuit different from that to 
which the receiver is connected.
- Consult the dealer or an experienced
radio/TV technician for help.
CAUTION
You are cautioned that any changes or 
modification not expressly approved in 
this manual could void your authority 
to operate this equipment.
Note to CATV system Installer:
Hus reminder is provided to call CATV 
system installer's attention to Article 
820-40 of the NEC that provides 
guidelines for proper grounding and, in 
particular, specihes that the cable 
ground shall be connected to the 
grounding system of dte building, as 
close to the point of cable entry as 
practical.
Owner's Record
The model and serial numbers are 
located on the rear of the unit. Record 
the serial number in die space provided 
below. Refer to them whenever you call 
upon your Sony dealer regarding d\is 
product.
Model No. STR-DA80ES 
Serial No_____________
For the customers in Canada
CAUTION
TO PREVENT ELECTRIC SHOCK, DO
NOT USE THIS POLARIZED AC PLUG 
WITH AN EXTENSION CORD, 
RECEPTACLE OR OTHER OUTLET 
UNLESS THE BLADES CAN BE FULLY 
INSERTED TO PREVENT BLADE 
EXPOSURE.
Precautions
On safety
• Should any solid object or liquid fall
into the cabinet, unplug the receiver 
and have it checked by qualified 
personnel before operating it any 
further.
On power sources
• Before operating the receiver, check
that the operating voltage is identical 
with your local power supply. The 
operating voltage is indicated on the 
nameplate at the rear of H\e receiver.
• The receiver is not disconnected from
the AC power source as long as it is 
connected to the wall outlet, even if 
the receiver itself has been turned off.
• If you are not going to use the
receiver for a long time, be sure to 
disconnect the receiver from the wall 
outlet. To disconnect the AC power 
cord, grasp the plug itself; never pull 
the cord.
• One blade of the plug is wider than
the other for the purpose of safety 
and will fit into the wall outlet only 
one way. If you are unable to insert 
the plug fully into the outlet, contact 
your dealer.
• Should the AC power cord need to be
changed, have it done at a qualified 
service shop only.
On placement
• Place the receiver in a location with
adequate ventilation to prevent heat 
buildup and prolong the life of the 
receiver.
• Do not place the receiver near heat
sources, or in a place subject to direct 
sunlight, excessive dust or 
mechanical shock.
• Do not place anything on top of the
cabinet that might block the 
ventilation holes and cause 
malfunctions.
On operation
• Before connecting other components,
be sure to turn off and unplug the
On cleaning
• Clean the cabinet, panel and controls
with a soft cloth slightly moistened 
with a mild detergent solution. Do 
not use any type of abrasive pad, 
scouring powder or solvent such as 
alcohol or benzine.
If you have any question or problem 
concerning your receiver, please 
consult your nearest Sony dealer.