Sony STR-DA80ES - Manual (Page 9)

&
Getting Started
Selecting the impedance
Set the IMPEDANCE SELECTOR for all the speakers
as indicated in the table below. Check the instruction
manual of your speakers if you're not sure of the
impedance^ (This information is usually printed on a
label on the back of the speaker.)
If nominal impedance of
your speaker is Set IMPEDANCE SELEQOR to
Between 4 arul 8 ohms 40
8 ohms or higher 80
Selecting the speaker system
If you connect only one set of front speakers, set the
SPEAKERS selector on the front panel to A. If you
connect two sets of front spe^ers, see tfie following:
To drive Set SPEAKERS selector to .
Speaker system A (connected
to the FRONT SPEAKERS A A
terminals)
Speaker system B (connected
to the FRONT SPEAKERS B B
terminals)
Bodi speaker systems A and B
(parallel connection) A+B
Notes
When y<Mi connect 2 sets of hont speakers uid set ¿ k
SPEAKERS selector on the hcmt panel to A + B, make sure'
diit:
• The nominal impedance of the both sets of speakers are
8 ohms or higher.
• The IMPEDANCE SELECTOR is set to 4 Q.
To connect any speaker pair through an amplifier
Connect the amplifier to the PRE OUT jacks of the
receiver to output die PRE OUT jack signals from the
amplifier's speaker terminals.
The signals output from the PRE OUT jacks are identical
to those output from the speaker terminals of the
receiver.
You can then connect any pair of speakers (e.g., the
front speakers) to the amplifier's speaker terminals.
TV/VCR Hookups
Overview
This section describes how to connect video
components to the receiver.
For digital coimections, see "Digital Component
Hookups" on page 10.
e*
TV/DBS’' VIDEO 2 MONITOR
LO/DVD VIDE01
^ TV/DBS; USA^ Canadian, and Australian models
TV: other models
What cables will I need?
• Audio/video cable (not supplied) (1 for each TV or LD
player; 2 for each VCR)
Yellow
White (D White (L)
Red(R) Red(R)
• Video cable (not supplied) (1 for a TV monitor)
Yellow Yellow
V If you want to watch high quality video images
You can use an S-VIDEO cable for the TV/DBS, LD,
VIDEO 1/2/3, and MONITOR jacks.
Note
The signal input from the S VIDEO IN jack is not output to
tire normal VIDEO OUT jack. Nor is the signal input from
the VIDEO IN jack output to the S VIDEO OUT jack.
Hookups . ^
The arrow indicates signal flow.
TV or Digital Broadcasting System (DBS) tuner
DBS tuners can be used with the USA, Canadian, and
Australian models.
Receiver
(Continued)