Sony KV-36XBR400 User Manual
Page 45
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
other Information
Programming the
Remote Control
The remote control is preset to operate Sony brand video equipment.
Sony
Equipment
Beta, ED Beta VCRs
8 mm VCR
VHSVCR
DVD Player
Switch Position
on Remote Control
VTRl
VTR2
VTR3
DVD/MDP
Programmable
Code Number
303
302
301
751
If you have video equipment other than Sony brand that you want to
control with the TV's remote control, use the following procedures to
program the remote control.
^ The equipment must have infrared (IR) remote capability in order to be used with the
remote control.
1
Bl To check if the code number
works, after step 5 aim the TV's
remote control at the component
and press the POWER button that
corresponds with that component. If
it responds, you're done. If not, try
using the other codes listed for your
component.
2
3
4
5
Tips
□
□
□
□
Turn to "Programmable Codes" on page 43, and find the three-
digit code number for your equipment. If more than one code
number is listed, use the number listed first to complete the
following procedure.
^ You must perform step 3 within 10 seconds of step 2, or you must start again from
step 2.
Press CODE SET.
Move the slide switch to the desired input.
Enter the three-digit code number.
Press ENTER.
If more than one code number is listed, try entering them one by
one until you come to the correct code for your equipment.
If you enter a new code number, the code number you previously
entered at that setting is erased.
In some rare cases, you may not be able to operate your
equipment with the supplied remote control. In this case, use the
equipment's own remote control unit.
Whenever you remove the batteries to replace them, the code
numbers may revert to the factory setting and must be reset.
42