Sony MDS-S35 - Manual (Page 9)

Recording on MDs
Marking Track Numbers While
Recording (Track Marking)
You can mark track numbers either manuallv t>r
automaticallv. Bv marking track numbers at specific
points, \’ou can c]Liickl\' locate the points later using the
AMS Functit>n or Editing Functions.
To cancel Automatic Track Marking
1 I’ress FDIT/NO during recording or recording pause.
"1 ew'lSvnc f" appears in the display.
2 I’ressVFS.
3 I’ress HniT/\0.
"1 .eyelSx'ncOFF" appears in the display.
* rhe signal level most remain krw hrr 2 trr more seconds
betöre a new track number is written.
EDIT/NO YES
Marking track numbers manually (Manual
Track Marking)
You can mark track numbers at any time while
recording on an MD.
When you want to mark track numbers after you've
done the recording
Use the Divide Function (see "Dividing Recorded Tracks"
on page.18).
Note
It vou turn off the deck or disconnect the AC power cord, the
deck will recall the last setting (Le\ elSvnc ON or OFF) of the
Automatic' Track Marking Function the next time vou turn on
the deck.
Press 9 at the place you want to add a track mark
while recording.
Marking track numbers automatically
(Automatic Track Marking)
The deck adds track marks differently in the following
cases:
• When recording from CDs or MDs with INPUT at
DIGITAL and the source connected through
DIGITAL IN:
The deck marks track numbers automatically. When
you record from a CD or MD, the track numbers are
written as they are found on the original.
• When recording with INPUT at ANALOG and the
source connected through LINE (ANALOG) IN, or
when recording from DAT with INPUT at DIGITAL
and the DAT connected through DIGITAL IN:
The deck marks a new track number wlienever the
signal level drops and rises to a certain point”
(Automatic Track Marking). If "LEVEL-SYNC" does
not light up, set the LewelSync to ON as follows:
1 Press EDlT/NO to display "LevelSync ?"during
recording or recording pause.
Press YES twice to display "l.,e\ elSync ON."
"EEVEE-SYNC" appears in the display.