Connecting a camcorder, Note – Sony KV-27V45 User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Connecting two VCRs for tape
editing using MONITOR OUT
• KV-27V40, 27V45, 27V65 only
MONITOR OUT gives you the ability to use a
second VCR to record a program being played
by the primary VCR or to perform tape
editing and dubbing.
1
Connect the VCR intended for playback
using the setup instructions on page 7 of
this manual.
2
Using A/V connectors, connect AUDIO
and VIDEO IN on your VCR intended for
recording to MONITOR AUDIO and
VIDEO OUT on your TV.
Connecting a camcorder
This connection is convenient for viewing a
picture directly from your camcorder.
Using A/V connectors, connect AUDIO and
VIDEO OUT on your camcorder to AUDIO
and VIDEO JN on your TV (Yellow-VIDEO,
White-AUDIO Left, Red-AUDIO Right),
Connection can also be made directly to your
A/V input located on the rear of your TV.
Note
• If vou are connecting a monaural camcorder,
connect only the single white audio output
to the left input on your TV.
You cannot change video
inputs while editing using
MONITOR OUT.
{Rear of KV-27V65)
Disconnect all power sources before making any connections.
VCR (for playback)
VIDEO (yellow)
AUDIO-L (white)
AUDIO-R (red)
VMC-810S/820S (not supplied) VMC-810S/820S (not supplied)
If you have an S Video equipped
camcorder, you can use an S Video
connection for optimum picture quality.
(Front of KV-27V40, 27V45, 27V65 only)
® ® ©
t
11