HP 2566C User Manual
Page 17
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
2. Turn the printer "OFF."
With the printer “off-line,” switch the main power ON/OFF (1/0)
switch located on the back of the printer to the “OFF” (0) position.
Unplug the power cable from both the AC outlet and the printer.
3. Disconnect the interface cable.
Unplug the printer’s interface cable from the rear of the printer.
4. Raise the levelers.
Turn the printer’s four leveling feet counter-clockwise and raise them
into the full UP position.
5. Install the shipping brackets (behind the casting).
The printer is shipped with four metal shipping lock brackets as
shown in their locations in Figure 2-1. The brackets should have
been removed when the printer was unpacked and saved for printer
relocation. Re-install them, behind the casting, for any m^jor
relocation of the printer as they provide protection from vibration
damage. New shipping brackets may be ordered through your
Hewlett-Packard Service Representative. Specify two each of part
numbers 02566-00231 and 02566-00236 (front and rear brackets)
and four each of part numbers 3020-0004 and 3020-0025 (bolts and
washers).
REAR
■SHtPPING-
Figure 2-1. Shipping Lock Bracket Locations
2-2 GETTING THE MOST FROM YOUR PRINTER AND PAPER