Checking the power level of batteries, Attaching of trigger grip – Canon AUTO ZOOM 1218 User Manual
Page 20
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Checking the Power Level of Batteries
After the batteries have been loaded, check the power level of the
batteries.
Press
the
battery
test
buttons
at
the
bottom
of
the
camera, and check the position of the needle seen in the battery
tester window.
1
For checking the mercury batteries, press the white button. If
‘
the needle is in the blue zone the batteries have sufficient
power level. Otherwise, the mercury batteries must be replaced.
O For checking the penlight batteries, press the red button. If
^ the needle is in the blue zone the batteries have sufficient
power level for power zoom, ISfps and slow motion. If the needle
is in the white zone the batteries have power level for power zoom
and 18fps only. And if the needle does not move past the red
zone, the penlight batteries must be replaced.
4 Always check the power level of the batteries before shooting.
Attaching of Trigger Grip
Align the connecting parts of the trigger grip and the camera and
attach the grip onto the camera by screwing the attachment screws
into the attachment sockets.