Canon E 200 User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
^ Inserting Batteries into Wireless
Controller
The wireless controller operates on two
R03/AAA batteries.
1. Remove cover from back by
pressing down and sliding in
direction of arrow.
2. Insert two R03/AAA batteries
following 0 and 0 markings.
Be careful not to reverse polarity
of batteries.
3. Replace cover following guide
grooves.
Q
Notes:
• Do not leave wireless controller exposed to direct sunlight or in hot or humid places.
• Autofocus function stops when remote sensor receives a signal from wireless controller.
• Wireless controller uses infrared beams to transmit signals, so sunlight or fluorescent light on the
remote sensor may shorten operating distance.
• Wireless controller will not function if RS-300 Rain Shield is attached to the camera.
11