Capresso Impressa J5 - Manual (Page 25)

25.
You can also program the output visually (chapter 11.2).
You can also re-program all buttons to different values. Re-pro-
gramming changes the outcome of the beverage permanently.
Re-programming is easy. The re-programmed values are stored
in the machine’s memory until you re-program it again.
Example: The 1-cup espresso button is set in the factory to 1.5
OZ volume, strength STRONG and temperature HIGH . To
re-program the 1-cup espresso button to 2.5 OZ , XSTRONG and
temperature NORMAL proceed as follows:
READY
1. Push and hold the Rotary Dial until the display shows RINSE .
2. Turn the dial clockwise until the display shows BUTTONS .
3. Push the rotary dial. The display flashes SELECT BUTTON .
4. Push the 1-cup espresso button. The display shows WATER
(this determines the volume in your cup).
5. Push the rotary dial. The display shows 1.5 OZ .
6. Turn the dial until the display shows 2.5 OZ .
7. Push the rotary dial. For two seconds the display shows OK
and then WATER again. You have now changed the coffee
volume from 1.5 to 2.5 oz for the 1-cup espresso button.
8. Turn the dial clockwise until the display shows STRENGTH .
9. Push the rotary dial. The display shows STRONG .
10. Turn the dial until the display shows XSTRONG .
11. Push the rotary dial. For two seconds the display shows OK
and then STRENGTH again. You have now changed the
coffee strength from STRONG to XSTRONG for the 1-cup
espresso button.
12. Turn the dial clockwise until the display shows TEMP .
13. Push the rotary dial. The display shows HIGH .
14. Turn the dial until the display shows NORMAL .
15. Push the rotary dial. For two seconds the display shows OK
and then TEMP . again. You have changed the temperature
from HIGH to NORMAL for the 1-cup espresso button.
16. Turn the dial clockwise until the display shows EXIT .
17. Push the rotary dial. The display shows BUTTONS .
18. Turn the dial until EXIT and push the dial. READY .
17.3 ENERGY SAVING MODE
The J5 is set to
ENERGY – . This means the machine is always
ready to brew coffee.
You can program an energy savings mode
ENERGY
✓
. The J5
will lower the stand-by temperature. In case you want to brew
coffee the machine will then heat up for approx. 30 seconds.
To change the energy setting:
Buttons
1-cup buttons:
2-cup buttons:
Hot water
Steam
Parameters
Volume:
Strength:
Temperature:
Volume:
Temperature:
Volume:
Temperature:
Duration:
Options
0.5 to 8.0 oz.
MILD, NORMAL, STRONG, XSTRONG
NORMAL, HIGH
0.5 to 8.0 oz. per cup
NORMAL, HIGH
0.5 to 15 oz.
REGULAR, NORMAL, HOT
3 to 120 seconds