Capresso Impressa J5 - Manual (Page 26)

READY ,
• Push and hold the Rotary Dial until the display shows RINSE .
• Turn the dial clockwise until the display shows ENERGY – .
• Push the rotary dial. The display shows SAVE –
• Turn the dial until the display shows SAVE
✓
.
• Push the rotary dial. For two seconds the display shows OK
and then ENERGY
✓
.
• Turn the rotary until the display shows EXIT .
• Push the rotary dial. READY .
17.4 SETTING THE TIME
Setting the time lets you set an auto-on time (chapter 17.5).
READY ,
• Push and hold the rotary dial until the display shows RINSE .
• Turn the dial clockwise until the display shows TIME
• Push the rotary dial. The display shows –:– Turn the dial to set
the hour and push the dial to confirm the hour setting.
• Turn the dial to set the minutes and push to confirm For two
seconds the display shows OK and then TIME .
• Turn the rotary until the display shows EXIT .
• Push the rotary dial. READY .
Please note: If you turn the machine off with the main power
switch (Fig. 1a) or if you unplug the machine or experience a
power outage, the actual time will not be retained. The next time
you turn the machine on, the display will first show
TIME –:– .
Turn the Rotary dial to set the hours, then push the Rotary dial.
Turn the Rotary dial again to set the minutes and push to
confirm. Now the
AUTO-ON time will be automatically restored
(see next chapter).
17.5 SETTING THE AUTO-ON TIME / UNIT ON
You can set a time at which the machine turns itself on. This way
you don’t have to wait for the machine to warm up. At the pro-
grammed time the J5 turns itself on, it will start heating and the
display will then show
RINSE . Just push the Rinse button and
within seconds you can brew your first cup of coffee.
Please note: Auto-on will only work if you set the actual time
and the main power switch is turned on (when the small red light
in the On/Off switch is illuminated, you know that the main
power is on).
Setting the time allows you to program an auto-on time.
READY ,
• Push and hold the rotary dial until the display shows RINSE .
• Turn the dial clockwise until the display shows UNIT ON .
• Push the rotary dial. The display shows –:–
• Turn the dial to set the hour and push the dial to confirm the
hour setting.
• Turn the dial to set the minutes and push to confirm For two
seconds the display shows OK and then UNIT ON .
• Turn the rotary until the display shows EXIT .
• Push the rotary dial. READY .
17.6 CHANGING THE AUTO-OFF SETTING / OFF AFTER
Your machine is pre-set to turn itself off 2 hours after last use.
You can set the Auto-Off from .5 hour to 15 hours or you can set
it to
INACTIVE . In this case the machine will not turn itself off
automatically.
Recommendations:
• If you use the machine only in the morning, leave the auto-off
at 2 hours.
26.