Capresso Impressa J5 - Manual (Page 30)

13. The machine pumps the fresh water through the system and
through the steam nozzle. During this operation, the Rinse
button blinks.
14. When the display shows EMPTY TRAY , remove the container
and then the drawer and tray.
15. Empty the drawer and the ground coffee container.
16. Replace the Dual Frother or the frothXpress.
HEATING . READY .
The machine is ready to make coffee again.
The machine will automatically remind you when it’s time to
decalcify again.
18.4 MANUAL DECALCIFYING
If you use very hard water it is possible that calcium builds up
prematurely. If your coffee does not come out as hot as before
it is a sign for calcium build-up. When this happens you can
manually start a decalcifying cycle as follows:
READY
• Push the rotary dial, until the display shows RINSE .
• Push the rotary dial again and turn it until the display shows
DE-SCALE .
• Push the rotary dial again to confirm that you want to use this
program now. The display shows EMPTY TRAY .
• Continue with the steps 2 through 16 of chapter 18.3 above.
The machine will automatically remind you when it’s time to
decalcify again.
19. EMPTYING SYSTEM BEFORE TRANSPORT
If you transport the machine or if you send it to another place
please follow these steps.
• Turn machine off with the On/Off switch (Fig. 2). The on/off
button is still illuminated.
• Remove the water tank and empty it and replace.
• Remove the complete drawer, empty all parts, wipe clean
and replace all parts.
• Remove beans from the bean container (chapter 20.2). If you
transport the machine only for a short distance, secure all
lids with a non-abrasive tape.
IMPORTANT / EMPTYING SYSTEM
To avoid frost damage during transport you must empty the
system as follows:
1. Turn machine off with the On/Off switch (Fig. 2). The on/off
button is still illuminated.
2. Remove the water tank.
3. Place a cup underneath the steam nozzle.
4. Push and hold the rinse button until the display shows
EMPTYING . A little bit of water or steam will flow through
the steam nozzle. The machine will turn itself off after
approx. 30 seconds.
5. Now turn the main power switch off (Fig. 1a) and unplug.
20. KEEPING YOUR MACHINE IN TOP SHAPE
Keeping your Impressa J5 in good working condition will main-
tain the taste and aroma of your coffee beverages.
• Start the day with fresh, cold water.
• Don’t fill more beans into the bean container than you use in
two or three days. Store the rest of your beans in a dry dark
place. Oxygen, light, heat and moisture diminish the aroma of
the coffee bean.
• If you have not used your machine for a few days, brew one
30.