CDI Torque MULTITEST Motorized Loader - Manual (Page 74)

6-2
2000-800-02 Motorized Loader
Torque/force transducers, purchased separately, are available in
ranges from 15-200 in oz, to 200-2000 ft lb. The Motorized
Control Loader System features accessory calibration
equipment including precision torque bars, certified weights,
calibration mounts and stands. Reaction arms, cables,
mounting plates and fixtures are also available for testing
tensiometers, compression and tension gauges, and torque
multipliers.
The 2000-800-02 includes a roll cabinet, part number 2000-100-
02, with heavy duty casters and nine drawers with ball bearing
slides for transducer and calibration equipment storage. An
extendable swivel monitor stand accepts mounting of the 2000-
810-01 Indicator for operator convenience.
Functional Description
This section describes major hardware components of the
torque tester, including the:
• Torque tester/calibrator,
• 2000-800-02 Motorized Loader,
• Loader rear panel controls,
• Ball handle adaptor,
• 4-in-1 transducer (accessory), and
• Extension arm (accessory).
• Motorized Control Box
Specifications
• Input Voltage: 115VAC ±10%, 50/60 Hz (Single Phase)
• Input current: 6.3 Amps.
• Output voltage to Motorized Control Box :12VDC, 1 Amp.
• Output voltage to Motor: 0 to 130 VDC.
• Ambient Temperature: 0ºC to 50 ºC.
• Control Horse Power Range: 1/4 Hp.
• Control speed Range: Up to 30:1
• Line Voltage Change Compensation: Negligible speed change
during (operational) line voltage fluctuations.
• Acceleration Range: 0.2 seconds at start and 0 sec to full
speed.
• Motor speed max 42 RPM.
• Output torque at the motor shaft: 270 in-lb.
• Motor Ratio gear: 60:1
• 2 Software limit switches.
• 2 Hardware limit switches.
• Dot matrix display: 4 lines by 16.
• 4 Function keys.
• 5 Cursor keys.
• 2 Command keys (RUN and STOP ).
• 2 Hardware logic control buttons (ON and OFF).
• 1 Emergency Stop (total disconnection of Motor Power).
• 2 RS-232 ports for connect ion to Tester & PC (Optional).
• 1 D-SUB 15 pin Connector (to Power Amplifier Unit).
• 1 D-SUB 9 pin Connector (to Torque Tester).