CDI Torque MULTITEST Motorized Loader - Manual (Page 77)

6-5
2000-800-02 Motorized Loader
The connector on single transducer cables contains
the EEPROM calibration memory chip. Never
attempt to remove the connector from the
transducer.
D — Linear Bearings
May be slipped over the reaction pins to reduce friction when
testing very small or high resolution electronic wrenches.
E — Reaction Pins
Hold the reaction block in place.
F — Reaction Block
The reaction block is positioned so that the reaction pins
straddle the wrench handle at the hand hold position specified
on the wrench.
G — Motorized Control Box
Control motor speeds, Run, Stop, Cycling up to 99,999 times.
H — Hand Crank
Turn hand crank on the loader to apply torque. 2000 ft lbs of
torque are generated with only 10 ft lbs of manual torque
applied.
Adjustable stops on the reaction pins may be raised
or lowered to level the wrench prior to loading. Do
not place a second stop above the wrench handle. It
is normal for the wrench handle to rise as it levels
itself under load.