Climadiff DVA180/305G - Manual (Page 92)

92
My wine cellar is not cold enough :
Select a lower temperature
The temperature in my wine cellar varies slightly :
1. The true temperature to take into account is the temperature in the
bottle. Instantaneous variations which you can read correspond to the
compressor's operating cycles and stops.
It is thanks to this principle of small variations repeated in the air of
your wine cellar that a favourable average temperature is obtained to
ensure your wines the best conditions of maturity.
2. Our wine cellars are extensively insulated to ensure a temperature as
stable as possible for your wines. Consequently, a variation of 1°C in
the temperature outside the bottle will only be evidenced by a
temperature variation of approximately 0.1°C in the liquid.
3. If the temperature read in your wine cellar is different from that usually
observed and it does not persistently vary (over several hours), please
contact the after-sales service of your retailer.
THE COMPRESSOR OF MY WINE CELLAR DOES NOT START
RUNNING (ARE YOU SURE ? OUR COMPRESSORS ARE
SILENT)
1. Is the ambient temperature of your room low (below the minimum
demanded temperature)?
2. Is the selected temperature too high ? Select the minimum possible
temperature (refer to the chapter "Temperature Setting" according to
your model) and check whether the compressor starts running without
touching it.
3. Is the electrical connection powered ? To check this, connect another
electrical device to the same outlet.
4. If despite both these checks the compressor does still not run, contact
the after-sales service of your retailer.