Detex V40 EHxR - Manual (Page 4)

Strike holes (2)
For 1/4-20 machine screws
drill #7 holes
No pilot hole necessary
for #14 self-drilling screws
(see fastener table)
screws or #14
Fasten tightly with
1/4-20x1" machine
lockwashers and
self-drilling screws
Mark centerline
finished floor
40 inches above
for unit
two 1/4-20x1" machine
screws or #14
self-drilling screws
Fasten loosely with
6
label temporarily
if necessary.
(see outside
trim instructions)
Trim input hole
5
Slide 99 strike locator
into mounting plate.
(if using a 98 strike, see
98 STRIKE INSTALLATION page)
1
holes
Mounting plate holes (2)
For 1/4-20 machine screws drill #7 holes.
For #14 self-drilling screws no pilot holes
necessary.
For sex nuts drill 3/8" holes.
(see fastener table)
and strike holes
Mark mounting plate
4
Punch marked
Mounting plate Hole
Strike holes
to mark trim hole
2
Mounting plate
hole
If necessary, remove
3
RECOMMENDED
101275 Page 4