Environmental Water Systems TT 1054 TWIN TANK - Manual (Page 10)

EWS, Inc. / Environmental Water Systems
www.EWSWATER.com
4.3-10
1: Once the regeneration cycles steps have been completed the;
Service Mode will be entered.
You will see alternating flashing Time of Day and Gallons Remaining
2: Now and only now is it time to add clean Softener Salt into the Brine Tank,
Maximum: RT Units - 200 lbs; TT Units - 300 lbs.
Recommended: Rock Salt
3: Slowly Open the 1” High Flow Bypass Valve outlet to the Service line or the 11/2” Outgoing
Valve outlet to the Service line (if applicable, keep plumbed bypass valve closed).
See Diagram Below.
4: Set the current Time of day using the Up and Down Arrows to adjust as needed. Please note for
afternoon time settings the PM designation in small letters in the Middle of the Display
window’s top edge should be illuminated.
5: Confirm the Level #1 Programming Address Displays with the Level #1 Factory Address Set-
ting Chart as shown on next page.
SLOWLY OPEN the outlet side
the bypass valve so water will
flow to the house. The system
is now ready for service
A) Inlet and Outlet Valves are Open. Ready for Service.
B) The display has returned to the “Time of Day” and “Service” mode and is ready to operate automatically.
If electricity fails, the electronic controller will keep in memory the pre-set program. Use “Up and Down” buttons to
reset thecorrect time of day.
STEP 5: FINAL SERVICE POSITION
Inlet
Side:
Open
Service
Position
Inlet Side Open
Outlet
Side:
Open
Service
Position
Outlet Side Open
SLOWLY OPEN the outlet side to the plumbed installation so water will
flow to the house. Keep the bypass valve closed.The system is now ready
for service
Bypass
Closed
STEP 4: THE “HOME STRETCH”