Environmental Water Systems TT 1054 TWIN TANK - Manual (Page 9)

www.EWSWATER.com
EWS, Inc. / Environmental Water Systems 4.3-9
5 - - - 10.0
· Fast Rinse Display [5- - - 10.0 ]
This is a hidden cycle - NO red dot will appear
Once the valve has Advanced into the Fast/Rinse
Cycle wait until the number (5) stops flashing.
Push the Extra Cycle Button Once to advance
Valve to the Service mode.
Service Mode designated by Alternating flashing
Time of Day and Gallons Remaining
Repeat the Regeneration Cycle steps once Again as follows
•
Tank Fill Display [ 1 - - - - 5.0 ]
Once the valve has Advanced into the Tank Tank Fill Cycle wait until the number (1) stops flashing. Push
the Extra Cycle Button Once to advance Valve to the next cycle.
•
Brine Making Display [ 2 - - - 15.0 ]
Once the valve has Advance into the Brine Making Cycle wait until the number (2) stops flashing. Push
the Extra Cycle Button Once to advance Valve to the next cycle.
•
Brine Rinse Display [ 3 - - - 60.0 ]
Once the valve has Advanced into the Brine Rinse Cycle Confirm the water is being Drawn out of the
Brine Tank. Allow the water to be drawn out of the tank until the air check activates, approximately 2-10
minutes. The Brine Tank will Not completely empty the water below the Air Check Level.
Push the Extra Cycle Button Once to advance the Valve to the next cycle.
•
Backwash Display [ 4 - - - 10.0 ]
The Backwash Cycle will Flow water Upward through the Mineral Bed to purge air bubbles and any color to
the Drain. Allow the Backwash to run until the Drain runs clean and clear, approximately 0-5 minutes.
Once the Drain is clean and clear Advance Push the Extra Cycle Button Once to advance Valve to the next
cycle.
•
Fast rinse (hidden cycle) Display [5- - - 10.0 ]
Once the valve has Advance into the Fast Rinse Cycle wait until the number (5) stops flashing. Push the
Extra Cycle Button Once to advance Valve to the Service mode.