Environmental Water Systems TT 1054 TWIN TANK - Manual (Page 8)

EWS, Inc. / Environmental Water Systems
www.EWSWATER.com
4.3-8
· Brine/Rinse Display [ 3 - - - 60.0 ]
Once the valve has Advance into the Brine/Rinse
Cycle wait until the number (3) stops flashing.
Push the Extra Cycle Button Once to advance
Valve to the next cycle.
NOTE:
A slight sound change of the water flow will occur as
the flow slows down through the valve.
NOTE:
While waiting for the Cycle to complete check for
leaks at Plumbing connections and Factory connec-
tions which have been loosened during Shipping and
Handling. Clean up the Work Area.
3 - - - 60.0
4 - - - 10.0
· Backwash Display [ 4 - - - 10.0 ]
Open the 1” High Flow Bypass Valve inlet into
the fully open position.
The Backwash Cycle will Flow water Upward
through the Mineral Bed to purge air bubbles and
any color to the Drain. Allow the Backwash to run
until the Drain runs clean and clear, approximately
0-5 minutes.
Once the Drain is clean and clear Advance Push
the Extra Cycle Button Once to advance Valve to
the next cycle.