ETS-Lindgren 95252-1 Bulk Current Injection Probes (Archived) - Manual (Page 12)

Conducted Emission BULK CURRENT INJECTION PROBES
8 © ETS-Lindgren, L.P. – February 2005
Rev C – PN 399263
Calibration Jig 95241-1 may be used for this determination.
Typical transfer impedance values for the Model 95242-1 Probe
when used as a sensor are:
Frequency
(MHz)
Z
T
(
Ω)
2 7
4 14
6 21
8 26
10 30
15 35
20 37
30 38
40 39
50 39.5
60 40
80 41
100 41
140 42
180 42
220 43
260 43
300 43
320 43.5
340 43.6
360 44
380 42.5
400 39
420 32
440 25
460 17
Table 2
High sensitivity and minimal core gap indicate that the current
probe should be used only on signal lines where heavy currents are
not encountered. Heavy currents may affect measurement
accuracy should current probe core saturation occur.
Archived 6/1/10