ETS-Lindgren 95252-1 Bulk Current Injection Probes (Archived) - Manual (Page 14)

Insertion Loss BULK CURRENT INJECTION PROBES
10 © ETS-Lindgren, L.P. – February 2005
Rev C – PN 399263
INSERTION LOSS
Insertion loss of the 94242-1 Bulk Current Injection Probe may be
measured at low signal levels. ETS-Lindgren offers this
measurement as a calibration service, please contact our calibration
department for more information.
EQUIPMENT
Signal Generator (50 Ohms) 2 to 400 MHz 400 to 1000
MHz
RF Voltmeter (50 Ohms) 2 to 400 MHz 400 to 1000
MHz
Calibration Jig 95241-1
95251-1
50 Ohm Termination VSWR <1.2 VSWR <1.2
Bulk Injection Current
Probe 95242-1 95252-1
Table 4
Archived 6/1/10