ETS-Lindgren 95252-1 Bulk Current Injection Probes (Archived) - Manual (Page 8)

Application BULK CURRENT INJECTION PROBES
4 © ETS-Lindgren, L.P. – February 2005
Rev C – PN 399263
TEST SETUP APPARATUS
The following equipment may be needed to set up the test
environment:
§ Current Injection Probes:
95236-1 (0.1 to 10 MHz)
95242-1 (2 to 400 MHz)
95252-1 (400 to 1000 MHz)
§ Calibration Jig 95241-1
For the current injection probes. When using the Model
95252-1 the Model 95251-1 Calibration Jig is
recommended. It is the same as the Model 95241-1 Jig
listed above except that it has been modified to proved
better high frequency characteristics for the Model
95252-1 injection probe.
§ Current Monitoring Probes
§ Signal Source/Generator
§ Power amplifier(s)
The power amplifier should be capable of supplying the
full rated power into the current injection probes (which
have a high VSWR) with a low harmonic content.
§ Spectrum analyzer or measuring receivers
§ Directional coupler
§ RF Voltmeter(s)
§ RF Absorbing Clamp
§ RF Attenuator
§ RF Loads
Archived 6/1/10