Hybrid Racing HR EG DC Kswap Mount Kit User Manual
Page 4
4
STEP 7 Once the paint has dried
reinstall the PASSENGER SIDE
FRAME BRACKET running the
supplied 4” bolts through the top
of the mount and thread them in-
to the bottom frame rail nuts.
Torque the new bolts into the
frame rail nuts to10ft-lbs. Next
use the supplied nuts and thread
them under the frame rail onto
the bolts making sure to torque
them down to 33ft-lbs.
Install Guide
STEP 9: Remove the studs from
the transmission using two
wrenches or if you have access a
stud remover. Basically your go-
ing to take two nuts tighten them
together and then loosen the
stud from the lower nut.
STEP
STEP
STEP
9
9
9
STEP
STEP
STEP
8
8
8
STEP
STEP
STEP
7
7
7
STEP 8 Bolt in the REAR
MOUNT BRACKET do not fully
tighten until the engine is in-
stalled and all mount bolts are in.
Once the engine is installed
torque the bolts down to 43ftlbs.