Hybrid Racing HR EG DC Kswap Mount Kit - Manual (Page 6)

6
Install Guide
STEP 13: Get the engine into a
position so that you can install
the BILLET DRIVER side
mount. Remember to keep eve-
rything hand tight until all of the
mounts and brackets are in-
stalled. Start wit the bolt 1 and
move to bolt 2.
STEP 14: Next install the billet
bracket into the steel bracket
loosely starting with the bolt that
attaches to the frame(1). Once
you have the long bolt installed
go ahead and attach the billet
mount (2) to the engine hand
tight. You may have to lower and
raise the engine to get everything
to line up. Once these bolts are
in you should be able to remove
your engine hoist or raise the en-
gine if you are using a lift.
STEP 15: Next drop the BILLET
REAR MOUNT into place and
bolt it in following the order in the
image to the left. Start with the
rear mount bolt (1). Next rock/
shimmy the engine until the top
bolt(2) lines up and install the
bolt loosely. Finally install the
lower bolt (3).
STEP STEP STEP 15 15 15
STEP STEP STEP 14 14 14
STEP STEP STEP 13 13 13
1
2
3
1
2
2
1