KMC Controls FlexStat Operation Guide - Manual (Page 4)

FlexStat 4 Operation Guide, Rev. R
Operation (Basic)
Navigation
Navigate the menus and change settings by press-
ing a combination of various arrow buttons and the
Enter button. Push the:
• Enter button to select and/or exit value editing.
• Up or Down button to move among entries.
• Right or Left button to move among value fields.
• Left button to return to the Home screen.
NOTE: Access to various functions may require a
password.
H/C, Fan, Occupancy, and Override
When the fan is commanded to run, the animated
“FAN” icon rotates (if programmed to). When the
fan command stops, the fan icon is motionless.
The “OCC” icon shows a sun when in Occupied
mode and a quarter moon when in Unoccupied
mode.
HEAT or COOL will show (and be animated when
there is an active command to move the room tem-
perature toward the setpoint via mechanical heat-
ing/cooling or an economizer), depending on the
current mode. This can also be turned OFF.
To override these modes from the Home (tempera-
ture display) screen, press the Left arrow button.
Press Up or Down to get to the desired line and then
Enter (twice) to edit the mode setting. Press Left to
exit to Home.
Main Menu and Settings
From the Home (temperature display) screen, press
the Right arrow button to enter the Main Menu. You
may need to enter a password to change any settings.
Room Temp. Setpoint Adjustment
From the Home (temperature display) screen, press
the Up or Down arrow button once to view the exist-
ing setpoint.
To temporarily change the setpoint, press the Up
or Down arrow button repeatedly until the desired
setting is displayed and press Enter. (If Enter is not
pressed, the display will return to the Home screen
after about ten seconds and the new setpoint value
will still be saved.) The new setpoint will hold until
the next schedule change.
To permanently change the setpoint for occupied
mode, go to the Setpoints section under the Main
Menu. (In the Setpoints menu, heating/cooling set-
points/setbacks and deadband can be changed with,
if required, the correct password access. See Set-
points on page 25 .)
WED 9/3 5:43 PM
COOL:
OCC:
FAN:
HUM: 31%RH
MAIN MENU
ABOUT
ADVANCED
ALARM
DATE/TIME
SCHEDULE
SETPOINTS
SYSTEM
ADVANCED
APPLICATION
CB PROGRAMS
COMMUNICATION
DATE/TIME
DEVICE
INPUTS
LIMITS
APPLICATION
DEGREES SCALE: °F
APP:
OPT: 1H/1C
ADDITIONAL SETUP
ROOF TOP
SYSTEM MODE
SYSTEM ENABLE: AUTO
OCCUPANCY OVERRIDE
OCC OVERRIDE: OFF
FAN MODES
UNOCC:
OCC: AUTO
AUTO
Override
Setpoint Adjustment
Home Screen
Override Screens
Configur
ation
Configuration Screens
Right
(Menu)
Left
(Override)
Down (Setpoint)
Up (Setpoint)