Troubleshooting guide, Tuning, adjusting & maintaining your vehicle, Service/repair – Losi LOSB0128 User Manual

Page 8

Advertising
background image

Losi TEN-sCTE RTR • iNsTRuCTioN maNuaL

8

EN

Troubleshooting Guide

Problem

Possible Cause

solution

Vehicle does not operate

Battery not charged or plugged in

Charge battery/plug in

ESC switch not “On”

Turn on ESC switch

Transmitter not “On” or low battery

Turn on/replace batteries

Motor runs but rear wheels
do not rotate

Pinion not meshing with spur gear

Adjust pinion/spur mesh

Pinion spinning on motor shaft

Tighten pinion gear setscrew on motor shaft flat spot

Transmission gears stripped

Replace transmission gears

Drive pin broken

Check and replace drive pin

Steering does not work

Servo plug not in receiver properly

Make sure the steering servo plug is connected to the receiver steering channel,
noting proper polarity

Servo gears or motor damaged

Replace or repair servo

Will not turn one direction

Servo gears damaged

Replace or repair servo

Motor does not run

Motor wire solder joint is damaged

Resolder the motor wire with the proper equipment

Motor wire broken

Repair or replace as needed

ESC damaged

Contact Horizon Hobby Product Support

ESC gets hot

Motor over-geared

Use smaller pinion or larger spur gear

Driveline bound up

Check wheels and transmission for binding

Poor run time and/or sluggish
acceleration

Battery pack not fully charged

Recharge battery

Charger not allowing full charge

Try another charger

Driveline bound up

Check wheels, transmission for binding

Poor range and/or glitching

Transmitter batteries low

Check and replace

Vehicle battery low

Recharge battery

Loose plugs or wires

Check all wire connections and plugs

Tuning, adjusting & maintaining Your Vehicle

• Examine your vehicle on a regular basis.
• Use a brush to remove dirt and dust.
• Look for damage to the suspension arms and other molded parts.
• Re-glue the tires to the wheels, if necessary.
• Use suitable tools to tighten fasteners.
• Make sure the camber and steering linkages are not bent. Replace any bent

linkages.

• Adjust the Toe and Camber settings, if necessary.
• Remove the shocks and inspect them for damage. Rebuild the shocks if oil is

leaking.

• Inspect electronics and batteries for exposed wires. Repair exposed wires with

shrink-wrap or replace the wire.

• Make sure the ESC and receiver are secure on the chassis. Replace the

double-sided tape, if necessary.

• Power on the transmitter. If the green LED is dim or off, replace the AA

batteries in your transmitter.

• Check the spur gear for wear.

service/Repair

Radio/Speed Control & Motor
If any problems other than those covered in the troubleshooting section arise,
please call the appropriate electronics service department. They will be able to
give the problem additional specific attention and provide instructions for the
solution.

Maintenance
If any questions other than those covered in the troubleshooting or maintenance
sections arise, please call the appropriate Horizon product support department.

Cleaning
Performance can be hindered if dirt gets in any of the moving suspension parts.
Use compressed air, a soft paintbrush, or a toothbrush to remove dust or dirt.
Avoid using solvents or chemicals as they can actually wash dirt into the bearings
or moving parts, as well as cause damage to the electronics.

Advertising