Losi LOSB0128 - Manual (Page 6)

Losi TEN-sCTE RTR • iNsTRuCTioN maNuaL 6
EN
installing the Battery
Three-Position Battery Tray
Your TEN-SCTE RTR comes with a three-position battery tray to alleviate the need
for foam blocks. You can move the included battery stops in order to run the
battery in a back, middle, or forward position. Please see the pictures as follows:
Batteries and Charging
The TEN-SCTE RTR uses rechargeable batteries such as NiMH or LiPo. These
batteries all have special requirements to preserve performance and last.
• Read all instructions provided by the manufacturer of the batteries.
• Never allow minors to charge battery packs.
• Always check to ensure the polarity of battery connection is correct.
• Never leave batteries unattended while charging.
• Never charge a battery while it is installed in the TEN-SCTE RTR .
• Do not charge any battery that appears to have any damage.
• If there are exposed wires, do not charge or use the battery until you install
shrink-wrap or replace the complete wire.
When charging NiMH or LiPo batteries, select a charger to meet your
requirements. You need a charger that is a 100–240V wall charger or one which
requires a 12V power supply. Follow the charger manufacturer’s instructions and
precautions during each use.
Back Middle
Forward