Mercedes-Benz SLS-Class 2015 Owners Manual - Manual (Page 214)

i Notes about the declaration of conformity
can be found here (
Y
page 22).
USA: FCC ID: CB2HMIHL4
Canada: IC: 279B-HMIHL4
Programming
Programing buttons
Pay attention to the "Important safety notes"
(
Y
page 211).
Integrated garage door opener in the rear-view mir-
ror
Garage door remote control A is not part of
the integrated garage door opener.
X Before programing for the first time, clear
the integrated garage door opener memory
(
Y
page 214).
X
Select key position 2 with the Start/Stop
button (
Y
page 119).
X Press and hold one of buttons ; to ? on
the integrated garage door opener.
After a short time, indicator lamp : lights
up yellow.
i Indicator lamp : lights up yellow as soon
as button ;, = or ? is programed for the
first time. If the selected button has already
been programed, indicator lamp : will
only light up yellow after ten seconds have
elapsed.
X
Release button ;, = or ?.
Indicator lamp : flashes yellow.
X Point garage door remote control A
towards buttons ; to ? on the rear-view
mirror at a distance of 2 to 8 inches (5 to
20 cm).
i The required distance between remote
control A and the integrated garage door
opener depends on the garage door drive
system. Several attempts might be neces-
sary. You should test every position for at
least 25 seconds before trying another
position.
X
Press and hold button B on remote control
A until indicator lamp : lights up green.
If indicator lamp : lights up green or
flashes, then programing was successful.
X
Release button B on remote control A for
the garage door drive system.
X If indicator lamp : lights up red: repeat the
programing procedure for the correspond-
ing button on the rear-view mirror. When
doing so, vary the distance between remote
control A and the rear-view mirror.
i If the indicator lamp flashes green after
successful programing, the garage door
system is using a rolling code. After pro-
graming, you must synchronize the garage
door opener integrated in the rear-view mir-
ror with the receiver of the garage door
system.
Synchronizing the rolling code
Pay attention to the "Important safety notes"
(
Y
page 211).
Your vehicle must be within reach of the
garage door or exterior gate drive. Make sure
that neither your vehicle nor any persons/
objects are present within the sweep of the
door or gate.
X
Select key position 2 with the Start/Stop
button (
Y
page 119).
X
Press the programing button of the door or
gate drive (see the door or gate drive oper-
ating instructions, e.g. under "Programing
additional remote controls").
212
Features
Stowag
ea
nd
features