Maintenance and care, Engine compartment – Mercedes-Benz SLS-Class 2015 Owners Manual User Manual

Page 222

Advertising
background image

X

Unscrew and remove oil filler cap : with

the integrated dipstick.

X

Wipe the oil dipstick.

X

Screw on oil filler cap : again to the stop.

X

Unscrew oil filler cap : again and read the

dipstick.

If the level is between MIN mark = and

MAX mark ;, the oil level is correct.

X

If the oil level has dropped to MIN mark =

or below, add 1.1 US qt (1.0 liter) engine oil.

Adding engine oil

G

WARNING

Certain components in the engine compart-

ment, such as the engine, radiator and parts

of the exhaust system, can become very hot.

Working in the engine compartment poses a

risk of injury.
Where possible, let the engine cool down and

touch only the components described in the

following.

G

WARNING

If engine oil comes into contact with hot com-

ponents in the engine compartment, it may

ignite. There is a risk of fire and injury.
Make sure that engine oil is not spilled next to

the filler neck. Let the engine cool down and

thoroughly clean the engine oil off the com-

ponents before starting the engine.

H

Environmental note

When adding oil, take care not to spill any. If

oil enters the soil or waterways, it is harmful to

the environment.

!

Only use engine oils and oil filters that

have been approved for vehicles with a

service system. You can obtain a list of the

engine oils and oil filters tested and

approved in accordance with the

Mercedes-Benz Specifications for Service

Products at any Mercedes-Benz Service

center.

Damage to the engine or exhaust system is

caused by the following:

R

using engine oils and oil filters that have

not been specifically approved for the

service system

R

replacing engine oil and oil filters after

the interval for replacement specified by

the service system has been exceeded

R

using engine oil additives.

!

Do not add too much oil. adding too much

engine oil can result in damage to the

engine or to the catalytic converter. Have

excess engine oil siphoned off.

X

Unscrew and remove oil filler cap : with

the integrated dipstick.

X

Add engine oil.

If the oil level is at or below the MIN mark on

the oil dipstick, add 1.1 US qt (1.0 l) of

engine oil.

X

Replace cap : on the filler neck and

tighten clockwise.

Ensure that the cap locks into place

securely.

X

Check the oil level again with the oil dip-

stick (

Y

page 219).

You will find further information about engine

oil in the "Technical data" section

(

Y

page 283).

220

Engine compartment

Maintenance

and

care

Advertising