Whe el sa nd tire s, Tire pressure – Mercedes-Benz SLS-Class 2015 Owners Manual User Manual
Page 261

Tire pressure monitor warning mes-
sages
If the tire pressure monitor detects a pressure
loss in one or more tires, a warning message
is shown in the multifunction display and the
yellow tire pressure monitor warning lamp
comes on.
R
If the
Correct Tire Pressure
Correct Tire Pressure
message
appears in the multifunction display, the
tire pressure in at least one tire is too low
and must be corrected at the next oppor-
tunity.
R
If the
Check Tire Pressure
Check Tire Pressure
message
appears in the multifunction display, the
tire pressure in one or more tires has drop-
ped significantly and the tires must be
checked.
R
If the
Tire Pressure Warning Tire
Tire Pressure Warning Tire
Malfunction
Malfunction
message appears in the mul-
tifunction display, the tire pressure in one
or more tires has dropped suddenly and the
tires must be checked.
Observe the instructions and safety notes in
the display messages in the "Tires" section
(
Y
page 182).
i
If the wheel positions on the vehicle are
rotated, the tire pressures may be dis-
played for the wrong positions for a short
time. This is rectified after a few minutes of
driving, and the tire pressures are displayed
for the correct positions.
Restarting the tire pressure monitor
When you restart the tire pressure monitor, all
existing warning messages are deleted and
the warning lamps go out. The monitor uses
the currently set tire pressures as the refer-
ence values for monitoring. In most cases, the
tire pressure monitor will automatically
detect the new reference values after you
have changed the tire pressure. However, you
can also define reference values manually as
described here. The tire pressure monitor
then monitors the new tire pressure values.
X
Set the tire pressure to the value recom-
mended for the corresponding driving sit-
uation on the Tire and Loading Information
placard on the driver's side
B-pillar (
Y
page 253).
Additional tire pressure values for different
loads can also be found on the tire pressure
table on the inside of the fuel filler flap
(
Y
page 253).
X
Make sure that the tire pressure is correct
on all four wheels.
X
Make sure that the SmartKey is in position
2 in the ignition lock.
X
Press the = or ; button on the steer-
ing wheel to select the
Serv.
Serv.
menu.
X
Press the 9 or : button to select
Tire Pressure
Tire Pressure
.
X
Press the a button.
The multifunction display shows the cur-
rent tire pressure for the individual tires or
the
Tire
Tire pressure
pressure will
will be
be displayed
displayed
after driving a few minutes
after driving a few minutes
mes-
sage.
X
Press the : button.
The
Use Current Pressures as New
Use Current Pressures as New
Reference Values
Reference Values
message appears in
the multifunction display.
If you wish to confirm the restart:
X
Press the a button.
The
Tire Press. Monitor Restarted
Tire Press. Monitor Restarted
message appears in the multifunction dis-
play.
After driving for a few minutes, the system
checks whether the current tire pressures
are within the specified range. The new tire
pressures are then accepted as reference
values and monitored.
If you wish to cancel the restart:
X
Press the % button.
The tire pressure values stored at the last
restart will continue to be monitored.
Tire pressure
259
Whe
el
sa
nd
tire
s
Z