Stowage and features, Features – Mercedes-Benz SLS-Class 2015 Owners Manual User Manual

Page 215

Advertising
background image

i

Usually, you now have 30 seconds to ini-

tiate the next step.

X

Press previously programed button ;, =

or ? of the integrated garage door opener

until the door closes.

The rolling code synchronization is then

complete.

Notes on programing the remote control
Canadian radio frequency laws require a

"break" (or interruption) of the transmission

signals after broadcasting for a few seconds.

Therefore, these signals may not last long

enough for the integrated garage door

opener. The signal is not recognized during

programing. Comparable with Canadian law,

some U.S. garage door openers also feature a

"break".
Proceed as follows:

R

if you live in Canada

R

if you have difficulties programing the

garage door opener (regardless of where

you live) when using the programing steps

X

Press and hold one of buttons ; to ? on

the integrated garage door opener.

After a short time, indicator lamp : lights

up yellow.

X

Release the button.

Indicator lamp : flashes yellow.

X

Press button B of garage door remote

control A for two seconds, then release it

for two seconds.

X

Press button B again for two seconds.

X

Repeat this sequence on button B of

remote control A until indicator lamp :

lights up green.

If indicator lamp : turns red, repeat the

process.

X

Continue with the other programing steps

(see above).

Problems when programing
If you are experiencing problems programing

the integrated garage door opener on the

rear-view mirror, take note of the following

instructions:

R

Check the transmitter frequency of garage

door drive remote control A. This can usu-

ally be found on the back of the remote

control.
The integrated garage door opener is com-

patible with devices that have units which

operate in the frequency range of 280 to

433 MHz .

R

Replace the batteries in garage door

remote control A. This increases the like-

lihood that garage door remote control A

will transmit a strong and precise signal to

the integrated garage door opener in the

rear-view mirror.

R

When programing, hold remote control A

at varying distances and angles from the

button that you are programing. Try various

angles at a distance between 2and

12 inches (5to 30 cm) or at the same angle

but at varying distances.

R

If another remote control for the same

garage door drive is available, repeat the

same programing steps with this remote

control. Before performing these steps,

make sure that new batteries have been

installed in garage door drive remote

control A.

R

Note that some remote controls only trans-

mit for a limited amount of time (the indi-

cator lamp on the remote control goes out).

Press button B on remote control A again

before transmission ends.

R

Align the antenna cable of the garage door

opener unit. This can improve signal recep-

tion/transmission.

Opening/closing the garage door

Once programed, the integrated garage door

opener A will assume the function of the

garage door system's remote control. Please

Features

213

Stowage

and

features

Z

Advertising