Mercedes-Benz CL-Class 2011 - Manual (Page 134)

Individualization is completed at the end of
the second part. You will see a message to
this effect. The data from the second part is
stored automatically.
Canceling the first or second part of
individualization
X Confirm Cancel by pressing W the
COMAND controller.
A prompt appears asking whether you
really wish to cancel.
X Select Yes or No and press W to confirm.
If you select Yes , individualization will be
canceled. The data from the part canceled
is not stored.
If you select
No , the current part begins
again.
Deleting existing individualization data
X Select Vehicle by turning cVd the
COMAND controller and press W to
confirm.
X Select System and press W to confirm.
X Select Voice Control and press W to
confirm.
X Select Delete individualization and
press W to confirm.
A prompt appears asking whether you
really wish to delete.
X Select Yes or No and press W to confirm.
If you select No , the process will be aborted.
If you select Yes , the individualization is
deleted. You will see a message to this
effect.
Bluetooth ® settings
General information about Bluetooth ®
Bluetooth ® technology is the standard for
short-range wireless data transmission of up
to approximately 10 meters. Bluetooth
®
allows, for example, the exchange of vCards.
Bluetooth
® is a registered trademark of
Bluetooth Special Interest Group (SIG) Inc.
Requirements for a Bluetooth ®
connection
You can connect mobile phones and
notebooks with COMAND.
To do so, the following conditions need to be
met:
R Bluetooth ® -capable devices, e.g. mobile
phones, must comply with a certain profile
in order to be connected to COMAND.
Every Bluetooth
® device has its own
specific Bluetooth ® name.
R Bluetooth ® must be activated in COMAND
and on the respective Bluetooth ® device;
see the separate operating instructions.
R the Bluetooth ® device must be "visible" to
COMAND in order for COMAND to find and
display it. For the setting procedures,
please see the operating instructions for
the Bluetooth
® device.
i Once a mobile phone has been
connected, reception and transmission
volume may change.
132
System settings
COMAND