Safety, Occupant safety – Mercedes-Benz CL-Class 2011 User Manual

Page 51

Advertising
background image

If the SmartKey has been removed from the
ignition lock or is in position

0, indicator lamp

42: does not light up.

G

Warning

If the red SRS 6 indicator lamp in the
instrument cluster and the 42
indicator lamp are lit at the same time, there
is a malfunction in the OCS. The front
passenger front air bag will be deactivated in
this case. Have the system checked by
qualified technicians as soon as possible.
Contact an authorized Mercedes-Benz
Center.
Only have the seat repaired or replaced at an
authorized Mercedes-Benz Center.
In order to ensure proper operation of the air
bag system and OCS:

R

Sit with the seat belt properly fastened in a
position that is as upright as possible with
your back against the seat backrest.

R

When seated, a passenger should not
position him/herself in such a way as to
cause the passenger's weight to be lifted
from the seat cushion as this may result in
the OCS being unable to correctly
approximate the passenger's weight
category.

R

Read and observe all warnings in this
chapter.

System self-test

The 42 indicator lamp
illuminates when you:

R

turn the SmartKey to position

1 or 2 in the

ignition lock

R

press the KEYLESS-GO Start/Stop button
once or twice

If an adult occupant is properly sitting on the
passenger seat and the OCS classifies the
occupant as an adult, the 42
indicator lamp illuminates and goes out again
after approximately 6 seconds.
If the seat is not occupied and the OCS
classifies the front passenger seat as being
unoccupied, the 4 indicator
lamp2 will illuminate and not go out.

G

Warning!

If the 4 2 indicator lamp does
not illuminate, the system is not functioning.
You must contact an authorized Mercedes-
Benz Center before seating any child on the
front passenger seat.

For more information, see "Problems with the
Occupant Classification System"
(

Y

page 50).

G

Warning

Never place anything between seat cushion
and child seat (e.g. a pillow), since it reduces
the effectiveness of the OCS. The underside
and rear side child restraint system must be
placed entirely on the seat cushion and the
backrest of the front-passenger seat
backrest.
If necessary, adjust the tilt of the passenger
seat backrest.
An incorrectly mounted child seat could cause
injuries to the child in case of an accident,
instead of increasing protection for the child.
Follow the manufacturer's instructions for
installation of child restraint systems.

Occupant safety

49

Safety

Z

Advertising