Floormat on the driver's side, Infrared reflective windshield, Loading, stowing and features – Mercedes-Benz CL-Class 2011 User Manual

Page 402: Features

Advertising
background image

make sure that new batteries have been
installed in the garage door remote control.

R

Align the antenna cable of the garage door
opener unit. This can improve signal
reception/transmission.

Opening or closing the garage door

Once programmed, the integrated remote
control will assume the function of the garage
door system's remote control. Please also
read the operating instructions for the garage
door system.

X

Turn the SmartKey to position

2 in the

ignition lock.

X

Press transmitter button ;, = or ? in the
overhead control panel that you have
programmed to operate the garage door.
Garage door system with fixed code:
indicator lamp : lights up continuously.
Garage door system with rolling code:
indicator lamp : flashes briefly and then
lights up for approximately two seconds.
This is repeated for up to 20 seconds.

i

The transmitter will transmit a signal for

as long as the transmitter button is being
pressed. The transmission will be halted
after a maximum of 20 seconds and
indicator lamp : will flash. Press the
transmitter button again, if necessary.

Clearing the remote control memory

X

Turn the SmartKey to position

2 in the

ignition lock.

X

Press and hold transmitter buttons ;
and ? for approximately 20 seconds until
indicator lamp : flashes rapidly.
The memory is cleared.

i

You should clear the remote control

memory before selling the vehicle.

Floormat on the driver's side

G

Warning!

Whenever you are using a floormat, make sure
there is enough clearance and that the
floormat is securely fastened.
The floormat should always be securely
fastened using the fastening equipment.
Before driving off, check that the floormat is
securely in place and adjust it if necessary. A
loose floormat could slip and hinder proper
functioning of the pedals.
Do not place several floormats on top of each
other as this may impair pedal movement.

X

Slide seat backwards.

X

To install: place the floormat in position.

X

Press floormat eyelets : onto retainer
pins ;.

X

To remove: pull the floormats off

retainers ;.

X

Remove the floormat.

Infrared reflective windshield

The infrared reflecting glass prevents the
vehicle interior from becoming too hot. It also
blocks radio waves up into the gigahertz
range.

400

Features

Loading, stowing and features

Advertising