Mercedes-Benz CL-Class 2011 - Manual (Page 147)

i Further information on "Last
destinations" memory can be found on
(
Y page 165).
Entering a destination using the map
Calling up the map
X To switch on navigation mode: press the
S function button once or twice.
X To show the menu: press the COMAND
controller W.
X Select Destination in the navigation
system menu bar by turning cVd the
COMAND controller and press W to
confirm.
X Select Via Map and press W to confirm.
You see the map with the crosshair.
:
Current vehicle position
;
Crosshair
=
Details of the crosshair position
? Map scale selected
Display = depends on the settings selected
in "Map information in the display"
(
Y page 169). The current street name can
be shown, provided the digital map contains
the necessary data, or the coordinates of the
crosshair if the geo-coordinate display is
switched on and the GPS signal is strong
enough.
Moving the map and selecting the
destination
X To scroll the map: slide the COMAND
controller XVY, ZVÆ or aVb.
X To set the map scale: as soon as you turn
cVd the COMAND controller, the scale bar
appears.
X Turn cVd until the desired scale is set.
Turning clockwise zooms out from the map,
turning counter-clockwise zooms in.
X To select a destination: press W the
COMAND controller once or several times.
You will see either the address entry menu
with the destination address or, if COMAND
is unable to assign a unique address, a
selection list.
X Select a destination by turning cVd the
COMAND controller and press W to
confirm.
If the destination is within the limits of the
digital map, COMAND attempts to assign
the destination to the map.
If the destination can be assigned, you will
see the address entry menu with the
address of the destination. If not, you will
see the
Destination from Map entry.
X To start route calculation: select Start
and press W to confirm.
Navigation
145
COMAND
Z