Mercedes-Benz CL-Class 2011 - Manual (Page 151)

X Confirm the selection by pressing W.
If the selected main category does not
contain any sub-categories, the point of
interest list appears.
If the main category selected contains sub-
categories, a list of all the sub-categories
appears as a selection list.
X Select the category by turning cVd the
COMAND controller.
X Confirm the selection by pressing W.
The point of interest list appears. It
contains the points of interest that are
available in the sub-category and which are
within the search radius.
i Search radius means: COMAND searches
within a radius of up to 100 km.
If COMAND does not find any points of
interest within this radius, it extends its
search range to approximately 200 km. If
COMAND finds one point of interest within
this radius, it finishes the search.
i If you select the ALL list item, the points
of interest list contains all points of interest
for all sub-categories in the
RESTAURANT
main category which lie within the search
radius.
If you select the
OTHER RESTAURANTS
Restaurant list item: the points of interest
list contains all the points of interest which
cannot be assigned to any sub-category of
the
Restaurant main category and that lie
within the search radius.
Point of interest list
Introduction
The illustration below shows an example
of the point of interest list for the
RESTAURANT main category and BREWPUB
sub-category in the vicinity of the current
position.
: Direction display from current position to
point of interest
;
Linear distance to the point of interest
=
Point of interest
?
Selected sub-category
i Depending on the point of interest
selected, COMAND uses different
reference points in determining the linear
distance to the destination:
R
vicinity of current position: the linear
distance is the distance of the point of
interest from the current vehicle
position.
R
vicinity of destination: the linear distance
is the distance of the point of interest
from the destination entered.
Selecting a point of interest
X Select the point of interest by turning
cVd the COMAND controller and press
W to confirm.
The full address of the point of interest
selected appears.
Navigation
149
COMAND
Z