Storing positions into memory, Recalling positions from memory, Lighting – Mercedes-Benz GL-Class 2009 Owners Manual User Manual
Page 116: Notes, From memory, Controls in detail
Lighting
114
M
Memory button
1, 2, 3
Memory position button
X
Adjust the seats.
X
On the driver’s side, additionally adjust the
steering wheel and exterior rear view
mirrors to the desired positions.
X
Press memory button
M.
X
Release memory button
M and press
memory position button
1, 2 or 3 within
3 seconds.
When the settings are stored to the
selected position, an acknowledgement
signal sounds.
X
Press and hold desired memory position
button
1, 2 or 3 until the seat has
completely moved to the stored position.
On the driver’s side, also wait for the
steering wheel and exterior rear view
mirrors to move to the stored position.
i
Releasing the memory position button
stops movement to the stored positions
immediately.
Lighting
i
If you drive in countries where vehicles
drive on the other side of the road than the
country where the vehicle is registered, you
must have the headlamps modified for
symmetrical low beams. Relevant
information can be obtained at any
authorized Mercedes-Benz Center.
i
Vehicles equipped with active Bi-Xenon
headlamps:
The active Bi-Xenon headlamps monitor the
vehicle’s steering angle and speed, then
automatically shift their beams to either
side to better follow the curvature of the
road ahead, increasing usable illumination
over conventional headlamps.
Controls in detail