Sewing on buttons – SINGER 1748 User Manual

Page 55

Advertising
background image

48

1

2

GB

Sewing on buttons

Install the darning plate. (1)

Change presser foot to button sewing foot (2).
Select zigzag stitch.

Position the work under the foot. Place the button on the

marked position, lower the foot. Adjust stitch width to "0" and

sew a few securing stitches. Set the stitch width to number "3" -

"5". Turn the handwheel to check that the needle goes cleanly

into the left and right holes of the button (adjust the stitch width

according to the button), and slowly sew on the button with

about 10 stitches. Adjust the stitch width to "0" and sew a few

securing stitches (3).

If a shank is required, place a darning needle on top of the

button and sew (4).
For buttons with 4 holes, sew through the front two holes first (3),

push the work forward and then sew through the back two holes.

4

3

Advertising