SINGER S18 - Manual (Page 10)

10
Winding a Bobbin
q Thread guides
w Bobbin winding tension disk
e Bobbin hole
r Notch
t Spring
y Bobbin winder spindle
u Bobbin winder lever/stopper
Step z
Pass the thread through the thread
guides
q from behind.
Step x
Pass the thread under the bobbin winding
tension disk clockwise. w .
Step c
Thread through the hole e in the bobbin from
the inside to the outside.
Match the notch
r with the spring t on the
bobbin winder spindle. Then insert the bobbin
on the bobbin winder spindle
y .
Step v
Push the bobbin winder lever/stopper to
the left
u .
Step b
Hold the free end of the thread in your hand
and press the bobbin winding button i . Press
the bobbin winding button again to stop the
bobbin when it has made several turns, and cut
the thread close to the hole on top of the bobbin.
Step n
Press the bobbin winding button again. When
the bobbin is fully wound, the machine will stop
automatically. Return the bobbin winder
lever/stopper to its original position.
Cut the thread with a scissors. Remove
the bobbin from the bobbin winder spindle.
x
c
v
b
n
This machine has an independent motor
for bobbin winding. Bobbins can be wound
while sewing.
q
w
e
r
t
y
u
i
Pull the thread guide bar up as
far as it will go. Stoppers will
click when fully extended.
Stopper
z