Vintage Cellars Wine Guardian Water-Cooled Cooling System - Manual (Page 29)

26
DO NOT:
√ DO NOT MODIFY THE PLUGS IN ANY WAY!
√ Do not use extension cords.
IMPORTANT
The electrical power supply must be either 115 volt or 230 volt AC 1 phase 60 cycle,
depending on the model of the unit, and cannot vary more than +/- 4% or damage
may occur to the unit.
Plug the unit into the wall outlet. Gently pull on the plug to make sure it is tight.
Electrical Plug Configuration
Installing the Thermostat and Control Wiring
Each Wine Guardian unit comes with a thermostat and 25 feet of wiring. It is wired at the factory for
testing prior to shipment. See start-up instructions in the thermostat guide for installation and opera-
tion of the thermostat.
Note
Keep the thermostat guide in a folder along with the Wine Guardian Manual for future refer-
ence.
Removing the Wires for Installation (If Necessary)
1) Note the color coding of the wires before removing.
2) Using the proper screwdriver, loosen the screws and pull the wire free.