Vintage Cellars Through-the-Wall Wine Cellar Cooling System Manual - Manual (Page 30)

30
4. Drill two 1/8” holes and insert anchors
(provided) within the mounting surface.
Anchors may not be required if securing to a
wall stud or racking system. (Fig. 3)
5. Plug in the communication cable to the back of
the Remote Sensor and attach to the wall using
the two screws provided in the kit. (Fig. 4)
6. Plug the Remote Sensor cables into the splitter
device at the WG unit along with the
communication cable for the Remote Interface
Controller. (Fig. 5)
NOTE: If using multiple Remote Sensors in one
wine room, continue to mount the remaining
sensors before installation of the sensor cover
plates. When multiple sensors are used, the
sensor jumper position must be adjusted in
order for proper averaging of temperature and
humidity readings. See page 27 for jumper set
up.
Fig. 3
Fig.4
Fig. 5
Fig. 6