Vinten Radamec Fusion FP-145 - Manual (Page 28)

27
To remove these panels proceed as follows:
1. Turn off the pedestal power (21) and disconnect the power lead (17) from the pedestal.
2. Unscrew the four fixing screws (12.1) and lift off the panel (12) to expose the internal mechanisms.
Routine checks
During use, check the following:
1. Check the balance of the pedestal. Re-balance as necessary.
2. Check the data communication with the control panel. Re-fit cables if necessary.
3. Check for radial or side play in the moving column.
Adjustments
Refer to the appropriate section in the Fusion FP-145/FPH-145 Pedestal Maintenance Manual (Publication
Part No. V3952-4991) if excessive radial or side play is apparent in the moving column, wheel alignment is poor
or any other defect is apparent. Adjustments and repairs should be carried out only by a competent person.
Routine maintenance
At three-yearly intervals, the three steel wire ropes in the column elevation mechanism should be replaced.
This procedure should be carried out by a competent person in accordance with the appropriate section in the
Maintenance Manual.