Welch Allyn Spot Vital Signs LXi - User Manual - Manual (Page 18)

8 Introduction Welch Allyn Spot Vital Signs LXi
Braun ThermoScan PRO 4000
These warnings are specific to the Braun ThermoScan PRO 4000 thermometer option.
SpO
2
Warnings
These warnings pertain to the Spot LXi SpO
2
feature.
WARNING Keep the probe window clean, dry, and undamaged at all times to ensure
accurate measurements. To protect the probe window, always keep the thermometer in
the storage cover while transporting or when not in use.
WARNING Only use Braun ThermoScan probe covers with this thermometer. Using other
manufacturer’s probe covers or no probe cover may produce temperature measurement
errors and/or inaccuracies. If the thermometer is used without a probe cover attached,
clean the lens (see “Braun ThermoScan PRO 4000 Thermometer” on page 60).
WARNING Do not autoclave.
WARNING The thermometer is not waterproof. Do not immerse or drip fluids on it.
Should this occur, dry the thermometer with warm air. Check for proper operation and
accuracy.
WARNING Only use Spot LXi with Masimo or Nellcor SpO
2
option with Masimo or Nellcor
brand sensors and accessories, respectively. Using the wrong or unapproved sensors or
cables may cause improper performance.
WARNING The SpO
2
sensor and extension cables are intended for use only for pulse
oximetry measurements. Do not attempt to connect these cables to a PC or any similar
device.
WARNING Before using, carefully read the sensor Directions for Use, including all
warnings, cautions, and instructions.
WARNING Do not use a damaged sensor or pulse oximetry cable or a sensor with
exposed optical components.
WARNING Incorrect application or a long duration of use of an SpO
2
sensor may cause
tissue damage. Inspect the sensor site periodically as directed in the sensor’s Directions
for Use.
WARNING Certain ambient environmental conditions, sensor application errors, and
certain patient conditions may affect SpO
2
readings and pulse signal.
WARNING Do not immerse the sensor or patient cables in water, solvents, or cleaning
solutions (the sensors and connections are not waterproof). Do not use irradiation, steam,
or ethylene oxide for sterilization.
WARNING The SpO
2
in the Spot LXi device is not intended for use as an apnea monitor.
WARNING Consider the SpO
2
an early warning device. As a trend toward patient
deoxygenation is indicated, use laboratory instruments to analyze blood samples to
completely understand the patient’s condition.