Welch Allyn Acuity and Mobile Acuity LT Central Monitoring Systems - User Manual - Manual (Page 170)

166 Chapter 10 Troubleshooting and maintenance Welch Allyn Acuity Central Monitoring System
Identify or change a Micropaq monitor network name
To identify a Micropaq monitor network name
1. Press to highlight SYSTEM INFORMATION, and then press .
The System Information menu appears.
2. Press to highlight NETWORK STATUS, and then press .
The Network Status screen appears.
3. Locate the Network Name in the list.
4. Press to exit.
To change a Micropaq monitor network name
1. Press repeatedly until SERVICE MENU is highlighted, and then press .
The Service menu appears.
2. In this sequence and not too rapidly, press and hold these keys:
, and .
An ARE YOU SURE? prompt appears.
3. Press to highlight YES, and then press .
A Network Name menu appears.
4. Press or to highlight the desired network name.
5. Carefully confirm that the highlighted name matches the appropriate Acuity System
network name.
6. Press .
The Micropaq monitor turns off and on again, and then it attempts to connect to the
Acuity System network.