Wine Guardian Through-the-Wall Wine Cellar Cooling Systems 50Hz (WG25) - Manual - Manual (Page 43)

42
Fig.1
安装 Wine Guardian 远程感应器（可选）
Installation of the Optional Wine Guardian
Remote Sensor
远程感应器仅可感应酒窖内的温湿度。该感应器应安装在酒
窖之内，可与本地界面控制器或远程界面控制器配合使用。
酒窖内最多可安装三个远程感应器。
The Remote Sensor is a combination temperature and humidity
sensor only. It is designed to be mounted within the wine cellar
and can be used in combination with Local Interface Controller or
the Remote Interface Controller and up to two additional Remote
Sensors to control multiple areas within the wine cellar.
安装远程感应器
Mounting the Remote Sensor
Fig.1（图1）
Fig, 2（图2）
1. 将远程感应器后部的通信电缆拔出，并将通信电缆
从墙上或天花板上接到控制器的安装地点。
1. Disconnect the communication cable from the back the
remote sensor. Install the communication cable within
the wall and/or ceiling structure of the wine cellar to the
desired controller mounting location.
请注意
Important
本感应器自带分线器。分线器须安装在WG设备上，请
勿将其装在远程界面控制器或感应器上，否则会导致组
件或系统损坏。
A splitter device has been supplied within the Remote
Sensor kit. The splitter device must be mounted at the
WG unit.. DO NOT mount the splitter device at the back
of the Remote Interface Controller or to the back of the
Remote Sensor as this WILL cause component or system
damage.
2. 将远程界面控制器安装在坚固表面上，注意要远离门、角
落、出气口、通风口或加热设备。请勿将控制器直接安装在
锅炉房外墙或紧邻锅炉房的墙上。如需将其安装在温度较高
或较低的表面，请先用泡沫绝缘材料垫在其背后。建议安装
高度为距地1.2到1.5米。