Wine Guardian Through-the-Wall Wine Cellar Cooling Systems 50Hz (WG25) - Manual - Manual (Page 53)

52
温差调整
Differential
temperature
adjustment
16号设定项
Setting 16
使用模式按钮进入16号设定项。
 Press “Settings” button to advance to Setting 16.
使用向上或向下键进行设定。
 Press the “Up” or “Down” buttons to adjust to
the desired setpoint.
本设备及压缩机将在室温超过预设值时启动。
出厂默认值为17摄氏度。
This setting changes the system/compressor; turn
on temperature above setpoint. Factory default is
set to 1 Deg C.
例如：感应器读数为12摄氏度
Example: Sensor reading = 13 Deg C
若将此处值设为-17摄氏度
Setting 16 Set to -1 Deg C
则系统/压缩机将在14摄氏度时启动
System/compressor turns on at 14 Deg C.
死区设定
Deadband setting
17号设定项
Setting 17
使用模式按钮进入17号设定项。
 Press “Settings” button to advance to Setting 17.
使用向上或向下键进行设定。
 Press the “Up” or “Down” buttons to adjust to
the desired setpoint.
此处值为增温与制冷点之间可容许的最小温
差。最大值为3摄氏度，最小值为1摄氏度。出
厂默认值为2摄氏度。
This setting is the minimal allowable temperature
difference between heating and cooling setpoints.
Maximum is 3 Deg C, minimum is 1 Deg C.
Factory default is set to 2 Deg C.