Canon FAX-L2000IP EN - Manual (Page 32)

Assembling the Machine 1-16
Be
fore Yo
u Start Using
This Mach
ine
1
NOTE
• There is no power switch on the main unit.
• The message below appears while it takes a few seconds for the machine to warm up.
• When you connect the power cord to an AC outlet for the first time after purchase,
<DISPLAY LANGUAGE> will appear in the LCD display after <PLEASE WAIT>. In this
case, set the language for the LCD display, and the country*. (See “Setting the Display
Language and Country”, on p. 1-29.)
* The country selection feature is available for certain countries only.
• The machine has warmed up and is ready to use when you see the date and time
displayed. Now the machine is in the Standby mode.
• When the date is displayed on the LCD display, the machine is in the Standby mode and
ready for normal operation. If the Error lamp starts blinking red, wait for one of the
following messages to appear.
PLEASE WAIT
FAX 31/12 2002 03:40
AUTO
Message Description
INSTALL CARTRIDGE You have not yet installed the toner cartridge. Install the
FX7 toner cartridge. (See “Installing the Toner Cartridge”,
on p. 1-11.)
REPLACE CARTRIDGE The toner cartridge has run out of toner. Replace the toner
cartridge.
CHECK PRINTER COVER The printer cover is not closed completely. If it does not
close easily, do not force it. Remove the toner cartridge,
and insert it again. Make sure it is sitting level inside the
main unit, and close the printer cover again.
SUPPLY REC. PAPER At least one of the paper cassettes is empty or not seated
correctly inside the machine. Remove each cassette.
Make sure the stacks of paper are below the hooks, and
insert the paper cassettes again. Push the paper
cassettes all the way into the machine until they lock into
place.