Petsafe Innotek FieldPro Remote Trainer - Manual (Page 4)

FieldPro-E Owner’s Manual EN-4
Put the collar around your dog’s neck and adjust to find the
proper fit. Fasten the collar so the fit is snug, yet loose
enough to allow one finger to fit between the strap and the
dog’s neck. Fit is important because a loose collar may
cause inconsistent performance.
Step 3
Fit the Collar on Your Dog
3 3 c cm m
2 2 3 3
Press
Step 4
Begin Training
Watch the included training DVD and read the information in the Training section
on page EN-17. Your dog may show good initial response to the training; be
sure to follow the training procedure for several weeks. The convenience that
your new remote training system offers is well worth the time invested.
RANGER ™ Quick Start Guide
Step 2
Turning the Receiver ON and OFF
1 1
The ON/OFF command only works
when the Transmitter and Receiver are
in close proximity; it will not work at a
distance. The ON/OFF command only
works when the Transmitter antenna
is installed.
Never turn the unit ON or OFF while
your dog is wearing the receiver
collar.
1 1.. Put the threaded end of the Antenna
into the Transmitter and turn until
finger-tight.
2 2.. Hold the Receiver one inch away
from the Transmitter— d
do o n no ott tto ou uc ch h
tth he e R Re ec ce eiivve err’’s s c co on ntta ac ctts s — — yyo ou u m miig gh htt
c ca au us se e s se ellff--tte es stt tto o ffa aiill.
3 3.. Press and hold the Tone button. The
Receiver’s light will turn on and show
the level of battery charge (solid
green, amber, or red). Release the
Tone button.
4 4.. To turn Receiver OFF, hold Receiver
and Transmitter one inch apart and
press and hold the Tone button. The
Receiver will emit a shut-down tone
sequence, and the light will glow
solid red, then go out. Release the
Tone button.
N NO OT TE E for T Tw wo o C Co olllla arr U Us se e:: Set the Transmitter
to Dog 2 and repeat steps 2 and 3 using the
second collar.
RANGER
™
Quick Start Guide