Storix Software SBAdmin Solaris System Recovery Guide - Manual (Page 13)

Select the Network Adapter that should be configured to connect to the remote install client. If
performing a network boot, then you may select UseBootAdapter to use the adapter that was used to
perform the network boot. If you configured the Client Network Adapter on the previous screen, you
can select UseInstallAdapter to use the same adapter configured for network installation.
Enter the IP Address used to configure the network adapter. This field will be disabled if you selected
to use either the boot or install adapter, which will already be enabled.
Enter the Subnet Mask (if necessary) used when configuring the network adapter. This field will be
disabled if you select to use either the boot or install adapter.
After pressing Done , the settings will be saved in the boot configuration. The adapter will be enabled, and a
remote connection (with appropriate password) will be accepted when booting from this media.
Configuring RIM after Booting from the Boot Media
To enable RIM from within the system Installation menus after booting from the SBAdmin boot media.
From within the system installation menus select System Recovery Utilities . Then select Configure
Remote Install Manager , and follow the instructions for Configuring Remote Install Manager in the
Utilities section.
Connecting to the Remote Install Process
To connect to the remote install client use one of the following:
a. SSH client program (i.e. “ssh sbadmin@192.168.1.121”): Note that you will always use the user id
“sbadmin” and the password you selected in the previous step. If you do not have an ssh client
program, you can use the one installed on the Network or Workstation Admin System. This program is
called strimsh (i.e. “/opt/storix/bin/stremsh sbadmin@192.168.1.121”).
or
Select Utilities !Start Remote Install Manager from the Network Administrator. A window will appear
where you must enter the remote install password:
Select the Remote Install Client Name from the drop-down list. The primary IP address of the client
will be shown in the Remote Install Client IP field. You may change this IP address if you are
connecting using a different adapter.
When you press the Connect button, a new terminal window will display, and the System Installation
Menus will appear. You can, from this window, perform all system installation and maintenance tasks
for the remote client.
Storix System Backup Administrator 13 Version 8.2 Solaris System Recovery Guide