Storix Software SBAdmin Solaris System Recovery Guide - Manual (Page 37)

6. View/Change Installation Settings
From the Main Menu, select View/Change Installation Settings. The first time you enter this option, the
backup information will be read from the installation media and compared with the system and disk
configuration to ensure there is adequate space on the available disks to perform the installation. Checks will
also be made to ensure you booted from boot media that supports all of the devices you will be restoring from
the backup. If there are any inconsistencies, you will be required to make changes within these menus to
correct the problem.
It is important to note that any options or changes made in these selections have NO
AFFECT on the actual disks or their contents until AFTER you begin the installation.
If you change your mind at any time, you can cancel or change information without
worry as to the state of the data on the disks!
The following is the Change Installation Settings Menu:
At times, you may be required to make changes throughout these menus to correct problems that would prevent
the devices from being created or the data from being restored. Only after returning to the
Main Menu by
pressing F3 or ESC, and selecting to begin the installation, will the data be checked again for consistency and
additional changes be required.
Select Disks to Use for Installation
If the disks detected on the system do not exactly match those described on the backup, this option will appear
automatically. Otherwise, you can select this option from the
Settings Menu to display a screen similar to the
following. We will refer to this as the Disk Table Menu.
Storix System Backup Administrator 37 Version 8.2 Solaris System Recovery Guide